WIRE NAIL MAKING
Wide experience has enabled us to offer newly designed 'NE' series
machines. These machines are equipped with compact geared type feeding
system. Thousands of our 'N series machines are satisfactorily working
in our country as well as abroad. Like our earlier 'N' series machines,
these machines are capable of producing different types of nail heads
The wire form wire coil passes through straightening rolls and fed
intermittently into the gripping dies which close firmly head of the
nail. The grip is loosened now and the required length of wire is fed
forward. Then the cutting tools cut the point a little forward of the
grip leaving sufficient wire projecting to form the head of the next
nail. This sequence of operations is repeated at each revolutions of the
machines and the nails are produced constantly.
The frame of the machine is extremely rigid, all moving parts are of
ample dimensions and precisely made from quality material under strict
quality control, which ensures the smooth running of machine in spite of
high rate of output.
Keeping in view to-day's technology, our machines are equipped with well
proven 3 shaft system. The main shaft controls Heading, while two side
shafts control Grapping, Cutting operations and nail length
operation, through gears, which ensures the accident-free motions.
The wire feed is actuated by means of gears mounted on one side shaft
which moves the feed slide through connecting-rod. The setting of the
desired length obtained quickly and easily.
The bush bearings are made from special metals and are of ample
dimensions. While manufacturing, care has been taken and provided with
continuous approach of oil which ensures the smooth running and long
Heavy load transmitting bearings are of needle roller type which ensures
the smooth running and long lasting.
The setting of the machine is made very easy and less time consuming;
even unskilled operators are able to handle the machines without
difficulty after a short time observation. Their special feature is
round type Grapping dies which gives 8/10 times the service of common
flat dies normally used in similar machines.
The main crank is counter-balanced and runs in 4 bearings in oil bath
chamber. Even smooth running and equal distribution of loads
ensure long life.
The bevel gears and the crank shafts are totally enclosed in oil chamber
and require no attention, except periodical checks. All other
lubrication points are served by a centralised pressure lubrication
Wire Diameter S.W.G. (mm)
: 10 - 4 (3.25 - 5.89)
Nail Length mm (inch)
: 100 - 150 (4" - 6")
Power Required hp/kW
Appox. Nett Weight kgs.
Appox. Gross Weight kgs.